Single stage Hammer Crusher

    The main working part of hammer crusher is rotors with hammer. The rotors consist of main shaft, disk, pin shaft and hammers. The motor drives the rotors to rotate quickly in the crushing cavity. Raw materials enter the crusher through the feed opening and are stricken, impacted, cut and ground by the high-speed hammer to small size. There is a screening plate under the rotor, so that materials with size smaller than the screen mesh will be screened out and others are left to be further hammered and ground until reach the standard size. The size of the final product can be adjusted by changing the screening plate. The gap between the rotors and the screening plate can also be adjusted according to different requirement.

Main Technical Parameters of Hammer Crusher:

Model	Max feed size(mm)	Rotor diameter mm	Rotor Length mm	Residual on the screen ≤15%	output (t/h)	Power(kw)	Weight (t) ( not include motor)
PCF-1412	600×600×900	1420	1200	≤25	80-120	220	23.5
PCF-1616	800×800×1000	1650	1630	≤25	180-220	315-355	43.3
PCF-1616 Ⅱ
PCF-1618	≤ 1m 3	1650	1830	≤25	240-280	400	49.5
PCF-1818	900×900×1000	1850	1830	≤25	300-350	560	70
PCF-2018	<1m 3	2020	1802	≤25	350-500	630-710	89
PCF-2018 Ⅱ	1000×1000×1000			≤25-75	350-450	630-700
PCF-2022	1000×1000×1500	2010	2230	≤30占90%	600-800	800	111
PCF-2022 Ⅱ	1000×1000×1500	2010	2230	≤70占90%	600-800	800	130
PCF-2022 Ⅲ	1000×1000×1500			≤80占90%	700-800	800
2PCF-1818	1000×1200×1500	1850	1830	≤75	1000	560	119
2PCF-2030	1000×1000×1500	2020	2230	≤25	700-900	800×2	142